In professional production and measurement units, special instruments are used to measure the radial runout of rolling bearings. When using the unit, you can use a simple method to measure if necessary to get an approximate value. The relevant measurement methods are described below.
1. Simple measurement method
(1) Feeler gauge measurement method
Insert a feeler gauge between the roller and the outer ring. When a person can be inserted with a little force, the thickness of the feeler gauge used is the radial clearance at that position. Rotate the inner ring of the bearing, measure 3 points evenly on a circumference, and take the average value as the measurement result. NSK HR 32912 J bearings online , pls click here :
(2) Simple measurement method of radial clearance of NSK radial rolling bearing
a. Oligopole measurement method;
b. Feeler gauge measurement method;
c. Economic pressure fuse measurement method;
d. Dial indicator measurement method.
(3) Extrusion fuse measurement method
Insert a piece of fuse with a fuse (commonly known as a fuse) into the gap between the two balls and hold it by hand, fix the inner ring of the bearing, rotate the outer ring, so that the fuse is squeezed between the outer ring and the ball, after squeezing, remove the fuse For wire, measure the thickness of the extruded part with an outside micrometer, that is, the radial free size of the NSK bearing. Since the squeezed part of the fuse may have a certain amount of "bounce" after it is withdrawn, the measured value will be slightly larger than the actual clearance value.
(4) Dial indicator measurement method
a. Press the inner ring of the NSK bearing on a flat plate that is perpendicular to the horizontal plane, and a layer of sheet is placed under the inner ring, so that the outer ring does not contact the flat plate and hangs down by its own gravity, and gently rotate the outer ring of the bearing. Make the ball contact the centerline of the inner ring and outer ring channel.
b. In the free state of the above-mentioned bearing, align the probe of the dial indicator with the middle of the upper side of the outer surface of the bearing outer ring. After adjusting the measuring force of the dial indicator, turn the cover to make the pointer align to the zero position ( When using a digital dial indicator, set the displayed value to zero).
c. Hold the lower end of the outer ring and push it along the radial (vertical upward) direction of the bearing with appropriate force to make the ball closely contact the inner and outer rings. Record the reading of the dial indicator. This reading is the radial clearance of the tested bearing at this position.
d. Rotate the outer ring by a certain angle, and then repeat the above operation to obtain several radial clearance values at different angles. Take the average value as the final result.
2. Simple measuring method of axial clearance
The axial clearance of NSK bearings is generally limited to radial ball bearings with relatively fixed inner and outer rings, which can be measured with special instruments. In the unit of use, the following simple methods are generally used.
A simple method of measuring the axial clearance of NSK deep groove ball bearings
(1) Press the inner ring of the NSK bearing on a platform, and padded a layer of sheet under the inner ring, so that the outer ring does not touch the platform when it sinks naturally under the action of its own gravity. Use a dial indicator on the end surface of the outer ring Measure a point value every 90° on the entire circumference of the center circle and make a record. When measuring, the pressure of the dial indicator on the bearing should be as small as possible to prevent the other end from lifting.
(2) Pull up the entire outer ring of the NSK bearing and keep it stable (supported by cushions). Use the same method and requirements to measure the same 4 points.
(3) Calculate the difference between the two measured values at each point and take the average of the absolute values, which is the final result of the measured bearing axial clearance.
Hot Tags: